adminwppnet

The so-called waste tires, refers to replaced or eliminated tires that have lost use value, and factory-generated scrap tire. The used tires have strong heat resistance, thermal biological, anti-mechanical, and are difficult to degrade, which will not naturally disappear for decades. Long-term open-air piling up, the waste tires will not only take up a lot … Read more

The storage of waste tires occupies a lot of land resources, which is easy to breed mosquito-borne diseases, seriously harmful to the environment, and may lead to fire. So the recycling of waste tire has attracted worldwide attention. Pyroysis oil from waste tires technology can not only make full use of waste tires, but also … Read more

  The waste tire pyrolysis equipment manufactured by Beston Group adopts the technology of “micro-negative pressure pyrolysis”, which can treat waste tires into four products: fuel oil, carbon black, steel wire and combustible gas. The pyrolysis oil from waste tires can be further refined into gasoline, diesel and asphalt by tire oil distillation plant. If … Read more

1. Transmission system of rotating processor: Check the lubricating oil surface inside the reducer regularly, and add lube in time. Check the containing impurities of the oil and timely replace the oil. Check the meshing condition of the gear, and adjust in time if there is any bad condition. 2. Reactor carrying idler Check oil … Read more

1. The innovative type heating structure has combined the advantages of direct heating and hot air heating, which can not only improve the production efficiency, but also lengthen the service life of the pyrolysis reactor. 2. The technology of preventing burning through the reactor can lengthen the service life of the reactor for another 2-3 … Read more

The objective of the present study is to convert waste tyres catalytically at relatively low temperature into liquid hydrocarbons as well as to drive liquid in the boiling range of commercial fuel oil. The liquid obtained from catalytic pyrolysis of waste tyre rubber were characterized in terms of fuel characteristics, because the liquid derived is … Read more

One of the problems with plastic recycling is economy as they need to be collected separately or sorted before the process can begin. When glass, paper and cans are recycled they become similar products, which can be used and recycled over and over again. With plastics recycling, however there is usually only a single reuse. … Read more

Introduction of continuous pyrolysis process The pretreated plastic, tyre, rubber, sludge or medical waste are conveyed to the horizontal pyrolysis reactor through auto feeding system. Then there will be oil gas generating gradually when the temperature rises up to 500℃. The oil gas will be cooled down and transformed into liquefied oil by spray cooling … Read more